I have another one if neccessary, but I think the screw shafts on it are clogged with plastic, so it might take some work as well.

  • _thebrain_@sh.itjust.worksEnglish
    2·
    5 days ago

    put them on a sheet of aluminum foil and put them on a cookie tray in your oven. set the oven to 450 degrees and bake it for a half hour plus. everything should melt out of it. you could even suspend it with a rolled up piece of foil under it. depending on the wires your thermistor may suffer but the heating element should be fine. tho, your thermistor probably will be okay too as it looks like it has silicone covering the wire.

      • _thebrain_@sh.itjust.worksEnglish
        2·
        5 days ago

        I don’t know. I’ve use this method several times and I’ve never had a problem. I probably should have specified that I’m in the states so 450° f versus 200 or 210° c that your printer runs at isn’t a huge difference. Sure. You run the risk of some fumes, but your printer is already belting the plastic. In that temperature. You need to go a lot hotter than 400° in order to set it on fire. It’s a lot safer than using a blowtorch